Delivery Reports GIVEUP

[Michael Wilding]

In the delivery reports, if an email has the status of GIVEUP, does this mean that all retries failed to send the email, or is it simply a log that there was an issue sending it. I'm trying to determine whether these emails have actually been sent or not.

Thanks

 

[frm.mwz]

In the delivery reports, if an email has the status of GIVEUP, does this mean that all retries failed to send the email

In previous versions it mean that. Then you could use AHK's extension.
In the new version, when you see that, try another manual run to see if it goes again, and if not, then it is done with internally set retries.
Then you can still use AHK's extension (perhaps change DS first)

 

[twisted1919]

@Michael Wilding - During a campaign sendout, is possible to see the giveup status for 3 times, as mailwizz retries sending.
However, once the campaign is sent, if you see the giveup status, it's for good, mailwizz did all it can do but it didn't work out.

 

[Michael Wilding]

Thank you. @twisted1919 on the retries does it end and start a new SMTP connection?

 

[frm.mwz]

@Michael Wilding - During a campaign sendout, is possible to see the giveup status for 3 times, as mailwizz retries sending.
However, once the campaign is sent, if you see the giveup status, it's for good, mailwizz did all it can do but it didn't work out.

But it is not retrying immediately when an error is received, but on another cron run, or when all non-errors are done, right? As it would be more likely to yield another error if done immediately. Better to allow some time in between, and ideally change DS. Can the 'on error change DS' be made an option?

 

[Michael Wilding]

Yeah that’s my question too @frm.mwz

 

[twisted1919]

Thank you. @twisted1919 on the retries does it end and start a new SMTP connection?

It's a totally different connection.

or when all non-errors are done, right?

This is correct, we move the failures at the end of the queue always.